Delta AP200 Shopmaster 1 Amp 850 CFM Air Filtration System

by Maria
(Hartsville, SC, USA)

I use my air purifier out in my woodworking shop. I have had it for about 1.5 years and I have to say for the most part I love it. Installation was fairly easy with a strong husband to held hoist it up in the air. It hangs near the ceiling on four strong chains.

I turn it on during a session of woodworking and it will cycle in the air in my shop about 20 times an hour according to the instruction manual. When I am ready to clean up, I vaccum every surface and then use an air compressor to spray the dust off every surface. I then close the door and run the air filtration system for a few hours. It works really well.

The filters are kind of pricey but so far I have been able to avoid buying new ones by using the air compressor to blow them off and reinstalling them afterward.

This machine was a great purchase and I am pleased with it.